Product Short Description

Product Name:​ Electronic Potentiometer / Electronic Speed Governor Interface (DEIF EPQ96-2)
Product Introduction:​ The EPQ96-2 is a digitally controlled, panel-mount electronic unit that replaces conventional motorized potentiometers for controlling electronic speed governors. It converts relay outputs from PI controllers into a control voltage, current, or PWM signal, and also incorporates a J1939-to-analog converter for CAN-based systems.

Description

Technical Specifications:
  • Supply voltage: 9 to 31.2 V DC (nominal 12/24 V); operates down to 5 V
  • Analog output: -10 to +10 V or -20 to +20 mA, 500 Ω output impedance
  • PWM output: 0 to 6 V, 500 Hz, open-collector with 1 kΩ pull-up
  • Resolution: 10-bit
  • Typical accuracy: 0.5%
  • Housing: 96 × 96 mm front profile, 92 × 92 mm cut-out
  • Adjustable ramp times: approximately 2.5–25 s or 12.5–125 s
  • Front protection: IP52; rear protection: IP20
  • Operating temperature: approximately -25 to +70 °C
Functional Characteristics:​ Supports manual and automatic modes via front push-buttons. Includes a relay output indicating auto mode, a status relay for correct function, and a built-in safety relay that disconnects the electronic circuit and retains a 500 Ω shunt resistor at the output terminals in case of supply failure. The unit powers up automatically in auto mode, with output selectable as a preset value or last stored value.
Application Scenarios:​ Used in marine and land-based power generation systems, diesel and gas engine control, and any application requiring replacement of motorized potentiometers for electronic speed governors.
Installation Requirements:​ Panel-mounted in a 92 × 92 mm cut-out. Rear terminals must be torqued to specification. A rotary switch on the rear selects preset/last-value behavior.
Usage Notes:​ For generators restarted after shutdown on “last” mode, an overspeed condition may occur with no load connected — preset mode is recommended. The two PWM outputs are not galvanically isolated and share a common return terminal.

Reviews

There are no reviews yet.

Be the first to review “Okuma EPQ96-2”

Your email address will not be published. Required fields are marked *

View Related Products