Moore Industries 16413-1-15

Description

• Designed for digital and analog industrial signal environments.
• Applicable in manufacturing, energy management, and process automation.

• Manufacturer:​ Moore Industries
• Model:​ 16413-1-15
• Module Category:​ Industrial I/O or combo communication module
• Communication Interface:​ RS-485 and Modbus RTU reported in distributor listings
• Digital Inputs:​ Up to 16 channels reported depending on variant
• Digital Outputs:​ Up to 8 or 16 channels reported depending on source
• Isolation:​ Channel-to-system isolation reported in supplier data
• Operating Temperature:​ Approximately -40°C to +70°C in wide-temperature listings
• Mounting:​ DIN rail or panel mounting depending on assembly

• Expands digital I/O capacity for industrial controllers.
• Supports Modbus RTU communication in listed configurations.
• Provides diagnostic or status indication through LEDs where equipped.
• Industrial noise immunity for factory environments.
• Modular design for control cabinet integration.

• Industrial control systems
• Energy management systems
• Smart manufacturing
• Process automation
• Machine control
• SCADA-connected I/O panels

• Industrial enclosure with DIN rail mounting capability.
• Terminal block or connector-based wiring interface.
• Compact rectangular module form factor.
• Designed for panel or cabinet installation.

• Acquires digital or analog field signals and transfers them to the controller.
• Executes output commands from the automation system.
• Uses serial communication where Modbus RTU capability is supported.
• Maintains electrical isolation between field circuits and control logic where specified.

• Install in a dry, ventilated control cabinet.
• Use appropriate DIN rail or panel hardware.
• Verify power supply voltage and polarity.
• Apply correct wire sizes and torque values.
• Ensure grounding and surge protection according to site standards.

• Do not operate beyond published voltage and temperature ratings.
• Avoid mixing incompatible signal types on shared terminals.
• Inspect insulation and terminations periodically.
• Prevent exposure to excessive vibration, moisture, or corrosive gases.
• Confirm exact model suffix before replacement because variants may differ significantly.