Description
Technical Specifications
- Sensing Range: 130 mm minimum dead band to 1300 mm maximum detection range
- Operating Frequency: 200 kHz ultrasonic transducer
- Supply Voltage: DC 18 V to DC 30 V
- Output Interface: IO-Link v1.1 + 1 x PNP switching output
- Resolution: 0.1 mm digital measurement resolution via IO-Link
- Repeatability: ±0.15 mm
- Beam Angle: 8° narrow ultrasonic sound cone
- Operating Temperature Range: -25 °C to +60 °C
- Protection Class: IP67 front housing, IP65 rear connector area
- Thread Mount Size: M30 x 1.5 male stainless steel thread
- Connector Type: M12 5-pin straight connector
Functional Features
- IO-Link digital communication for parameterization, diagnostic data readout and continuous distance value transmission
- Built-in temperature compensation to eliminate measurement drift under thermal fluctuation
- Multiple filter modes for suppression of airborne dust, mist, foam and turbulent air flow
- Synchronization function for multiple adjacent sensors to prevent cross-talk interference
- Adjustable switching window, hysteresis and response delay via IO-Link master
- Integrated LED status indicator for power, switching state and communication diagnostics
Structural Characteristics
- Front transducer: PTFE coated ultrasonic membrane resistant to chemical splashes
- Main housing: Reinforced PA66 glass-filled plastic
- Mounting thread: AISI 304 stainless steel corrosion resistant
- Internal circuit: Potting sealed electronics to resist vibration and moisture ingress
Working Principle
Emits high-frequency ultrasonic sound pulses toward target surface; measures time-of-flight of reflected echo to calculate linear distance between sensor and measured object. Digital signal processor filters echo signals to distinguish valid target reflections from background noise.
Advantage Highlights
- Narrow 8° beam eliminates false detection from side obstructions in confined installation spaces
- IO-Link enables full digital data transmission without analog signal attenuation over long cable runs
- Wide temperature operating window supports outdoor and refrigeration process deployment
- Stainless steel thread withstands washdown and light chemical exposure
- Zero mechanical wear from non-contact measurement, extending service life
Applicable Industries
Automotive assembly, packaging machinery, material handling conveyor systems, water treatment level monitoring, logistics sorting equipment, food & beverage processing
Installation Requirements
- Mount via M30 threaded nut; use rubber mounting washer to absorb mechanical vibration
- Maintain minimum 130 mm clearance between transducer face and nearest fixed obstruction
- Cable length limited to 20 m for IO-Link communication without signal repeater
- Avoid direct installation facing strong air jets, steam nozzles or high-temperature heat sources
Operation Precautions
- Do not scratch or abrade PTFE transducer membrane; surface damage distorts ultrasonic beam
- Prevent continuous condensation buildup on sensor front face; install air purge fitting for high-humidity environments
- Calibrate sensor target window after temperature shift exceeding ±10 °C
- Isolate adjacent MIC+ sensors via synchronization function when mounted less than 300 mm apart
Reviews
There are no reviews yet.