ABB C633-0001-R02KO1M0VSE2

Actuator Variant Technical Specifications:​ Supply 24 VDC. Current 2.5 A in one listing. Stroke 100 mm in one listing. Maximum load 1000 N in one listing. Maximum speed 100 mm/s in one listing. Operating temperature -20 to 80 °C. Protection IP65.

Analog Input Variant Technical Specifications:​ One channel in listed variants. Resolution 16 bits. Voltage input ±10 V or 0 to 10 V depending on source. Current input ±20 mA or 0 to 20 mA depending on source. Sampling 1 kHz in one source and 50 kHz in another source. Power 24 VDC. Communication RS232, GPIB, or proprietary servo interface depending on variant. Dimensions 100 x 50 x 20 mm in one source and 100 x 100 x 80 mm in another source.

Material And Structure:​ Industrial metal/PCB module with servo connectors, signal conditioning, and in actuator variants machined housing, ball or lead screw, motor section, and sealed joints.

Working Principle:​ In analog variant, input voltage or current is converted to digital values and transmitted to servo drive or controller. In actuator variant, control signal drives motor and transmission to produce linear motion; position feedback maintains stroke, force, and speed accuracy.

Installation Requirements:​ Install in controller rack or actuator mount according to Moog drawings. Provide 24 VDC within rated current margin. For servo valves connect command, feedback, and enable signals with shielded cable. For actuators align mechanical load axis to avoid side forces. Verify IP65 sealing for harsh environments.

Usage Precautions:​ Do not exceed 24 VDC auxiliary, 2.5 A actuator current, 1000 N load, or 100 mm/s speed ratings. Check servo hydraulic supply pressure and filter condition where the module controls hydraulic servo valves. Avoid electrostatic discharge when handling PCB variants. Confirm firmware, connector pinout, and drive compatibility before replacement.