BACHMANN BT5N071010HS000656

Material And Structure:​ Industrial printed-circuit module with metal or molded housing, signal connectors, communication ports, and DIP or software configuration. Exact mechanical drawing must be obtained from the nameplate manufacturer.

Working Principle:​ Input signals are conditioned, digitized at the stated resolution, and processed by the control firmware. Output regulation commands and communication frames are sent to connected drives, sensors, or supervisory controllers.

Installation Requirements:​ Mount in control cabinet with correct DC supply and grounding. Verify compatibility with Mark VI or other controller family before insertion. Use shielded analog cabling for ±10 V signals. Confirm firmware version and address settings.

Usage Precautions:​ Because supply voltage, temperature range, and dimensions vary between third-party listings, do not commission until the physical label is verified. Avoid mixing Suetron, GE, and Bachmann electrical product data. Perform calibration and self-test under the original equipment manufacturer procedure.

YOKOGAWA BUS-PCINO7102A

Verification Status:​ No YOKOGAWA technical datasheet for BUS-PCINO7102A was located. The part number BUS-PCI NO.7102A is documented under Contec as a PCI data-acquisition or industrial interface board. Apply the data below only when the physical card confirms Contec BUS-PCI NO.7102A.

Product Name:​ Contec BUS-PCI NO.7102A PCI data-acquisition and interface board.

Product Overview:​ Industrial PCI board for analog input acquisition and bus-based communication with controllers, test systems, and SCADA workstations. It is used where 16-bit measurement and multiple input ranges are required.

Technical Specifications:​ PCI local bus 32-bit, 33 MHz. Signaling 5 V in legacy listings and 3.3/5 V universal keying in other Contec-compatible listings. 16-bit resolution. Channels 8 differential or 16 single-ended depending on configuration. Input ranges ±10 V, ±5 V, ±2.5 V, ±1.25 V, ±0.625 V in acquisition-oriented listings. Sampling up to 250 kS/s per channel in acquisition-oriented listings. Connector 120-pin PCI edge or industrial header depending on variant. Operating temperature 0 to 60 °C in one listing and -10 to 60 °C in another listing. Storage -20 to 70 °C. Humidity 10 to 90 percent non-condensing. Drivers for Windows and Linux. Compliance CE and FCC Class A; RoHS depending on batch.

Material And Structure:​ FR4 PCI card with metal bracket, gold-plated edge connector in some listings, ADC components, multiplexer, reference circuitry, and firmware configuration EEPROM.

Working Principle:​ The PCI host issues acquisition commands. The multiplexer selects channels, the ADC converts analog input to 16-bit digital data, and the driver transfers samples to the host computer through PCI bus mastering or programmed I/O.

Installation Requirements:​ Install in a standard PCI slot with correct 3.3 V or 5 V keying. For universal cards confirm BIOS PCI allocation. Install Contec CTRLIB or official driver for the operating system. Use shielded cables for analog inputs to reduce EMI.

Usage Precautions:​ Do not force a 5 V-only card into a 3.3 V or PCIe slot. Verify driver signature for modern Windows versions. Inspect gold fingers for oxidation before installation. Avoid ground loops by using differential inputs for noisy signals. Maintain ambient temperature within the specified operating range.